TM 9-2350-222-20-1-4
MECHANICAL TRACK ADJUSTING LINK REPLACEMENT (Sheet 2 of 5)
REMOVAL:
1.
Using wire brush and rag, clean off both
ends of adjusting link (A).
NOTE
Due to a configuration change,
link pin that secures adjusting
link to roadwheel arm was
reversed and is now installed
with threaded end toward hull
of tank.
2. Using pliers, straighten cotter pin (B) and
remove it from slotted nut (C) at roadwheel
support arm. Throw cotter pin away,
3.
Using 1-1/8 inch socket, remove nut (C) and
washer (D) from pin (E).
4. Using 3/4 inch socket, remove screw (F)
securing pin (E) to link (A). Remove
lockwasher (G). Throw lockwasher (G)
away.
Go on to Sheet 3
TA249126
Change 3
14-57