TM 9-2350-222-20-1-4
SUSPENSION TORSION BAR REPLACEMENT (Sheet 6 of 7)
6.
Using crowbar (or pinch bar), apply upward
pressure to support arm (B) until blind spline
on bar (A) and index marks on support arm
(B) are alined.
7.
Using slide hammer puller and adapter,
push end of bar (A) in as far as it will go.
Remove blocks and crowbar.
8.
Remove slide hammer and adapter.
9.
Apply grease to end of bar (A).
10.
Using adjustable wrench with plug wrench , screw end plug
(C) and spacer (D) into place. Remove plug wrench.
11. Secure spacer (D) and end plug (C) with new
lockwasher (E) and screw (F).
12. Using deep socket with ratchet, tighten screw
(F).
Go on to Sheet 7
14-29
Change 5