TM 9-2350-222-20-1-4
SUSPENSION TORSION BAR REPLACEMENT (Sheet 5 of 7)
Apply grease (Item 36, Appendix D) to splined
1.
. ends of torsion bar (A).
Fill outer end opening with grease (1/4-inch
2.
deep).
Insert unmarked end of bar (A) into roadwheel
3.
support arm (B) housing.
Rotate bar so that index mark is at top.
4.
Push bar (A) through housing until inside end
5.
enters anchor on other side of tank. When this
is done, about 1/2 inch of bar will be out of
housing.
TA141310
Go on to Sheet 6
14-28 Change 1
PIN: 049275--004
U.S. GOVERNMENT PRINTING OFFICE 1991 5 4 3-0 2 5/ 40054