SUSPENSION TORSION BAR REPLACEMENT (Sheet 2 of 7)
Install plug wrench (Item 26, Chapter 3,
Section I) into end plug (C).
It may be necessary to use 36 inch
Using adjustable wrench on plug wrench,
loosen end plug (C).
Remove end plug (C) and spacer (D).
Have second person start engine. Then shift
transmission into reverse and slowly back tank
Direct second person to stop tank when support
arm (F) is in down position.
Using mallet, tap special roadwheel lifter off
spindle stub. Remove lifter.
Go on to Sheet 3