TM 9-2350-222-20-1-4
SUSPENSION TORSION BAR REPLACEMENT (Sheet 2 of 7)
2.
Install plug wrench (Item 26, Chapter 3,
Section I) into end plug (C).
NOTE
It may be necessary to use 36 inch
bar extension.
3.
Using adjustable wrench on plug wrench,
loosen end plug (C).
4.
Remove end plug (C) and spacer (D).
5.
Have second person start engine. Then shift
transmission into reverse and slowly back tank
up.
6.
Direct second person to stop tank when support
arm (F) is in down position.
7.
Using mallet, tap special roadwheel lifter off
spindle stub. Remove lifter.
Go on to Sheet 3
Change 5
14-25