TM 9-2350-222-20-1-4
HUB ASSEMBLY REPLACEMENT (Sheet 6 of 7)
14, When nut (P) is tight and parts seem to be seated, back off nut and, using torque wrench, tighten
nut (P) to 50-70 lb-ft (68-95 N.m)
15. Back off round nut (P) 1/4 turn.
16. Install lock (Q) so that hole of lock fits over nut (P) dowel.
NOTE
If lock hole does not line up to dowel of nut, turn lock over
and try other side.
17. Position new bearing nut lock (R) to one of holes in lock (Q).
18. Screw nut (S) onto arm (G) lower spindle. Tighten nut up against bearing nut lock (R).
19. Using 2-1 /2 inch socket and torque wrench, tighten nut (S) 150-300 lb-ft (202-406 N.m).
20. Using hammer and drift punch, bend one end of bearing nut lock (R) back over nut (S).
Go on to Sheet 7
TA253464
14-20 Change 1