TM 9-2350-222-20-1-4
HEADLIGHT HARNESS BASE ASEMBLY REPLACEMENT (Sheet 4 of 4)
NOTE
Make sure to connect connec-
tors properly. Use metal tags
for identifying proper connect-
ions.
5.
Apply silicone compound (Item 32, Appendix
D) to six mating connectors (H) of front har-
ness inside vehicle.
6.
From inside vehicle, connect six connectors
(J) of base assembly to mating connectors (H)
of front harness.
Using screwdriver, install new lockwasher
7.
(K), ground lead (L), new lockwasher (M),
and screw (N) securing ground lead to hull.
8.
Place six mated connectors (H and J) in position in bracket assembly (P) by pushing up .
9.
10. Install personnel heater (page 19-22), if right headlight base assembly was replaced.
TA253337
End of Task
10-250 Change 1