TM 9-2350-222-20-1-4
MASTER CONTROL PANEL REPAIR (Sheet 27 of 65)
Bilge Pump Switch and Indicator Light Replacement (Sheet 2 of 4)
NOTE
If necessary, use adjustable wrench to remove adapter (E).
4.
Using fingers, remove lens (D) and adapter (E) by turning counterclockwise.
5.
Using fingers, remove preformed packing (F) from adapter (E). Throw preformed packing (F)
away,
6.
Using fingers, remove lamp (G) by pushing in and turning counterclockwise.
7.
Using fingers, remove electrical connector from rear of base assembly (H) by pulling out.
8.
Using screwdriver, remove two screws (J) and lockwashers (K) securing base assembly (H) to panel.
9.
Remove base assembly (H).
Go on to Sheet 3
TA139637
10-81