TM 9-2350-222-34-1
AMMUNITION RACK REPAIR (Sheet 1 of 1)
TOOLS:
Aluminum welding outfit
1/8 in. twist drill
Portable electrical drill, 1/4 in.
SUPPLIES:
3/32 in. thick aluminum stock
REFERENCES:
TM 9-237
TM 9-247
TM 9-2350-222-20-1
TM 9-2350-222-34-2
REPAIR:
NOTE
Repair of the ammunition rack
consists of welding cracks and
broken welds. Welding can be
accomplished with the ammunition
rack in the turret or removed from
vehicle.
1.
Using 1/8 inch drill, drill hole through metal at each end of crack.
2.
Remove finish from approximately 1-1/2 inches on each side of crack and clean area (TM 9-247 ).
3.
Measure length of crack and cut a strip of 3/32 inch aluminum, 2 inches wide and length of crack.
4.
Weld boken welds or aluminum strip to cover crack (TM 9-237).
5.
Inspect welded area and remove rough or high spots inside and outside ammunition tube.
6.
Clean welded area and treat surfaces (TM 9-237).
7.
Install ammo rack (TM 9-2350-222-20-1).
8.
Install turret if removed (TM 9-2350-222-34-2).
End of Task
TA130826
11-29/(11-30 blank)
