TM 9-2350-222-34-1
REAR DRAIN VALVE INTERCONNECTING (INTERMEDIATE) CONTROL ROD AND UNIVERSAL JOINTS
REPLACEMENT (Sheet 8 of 9)
13. Push universal joint (M) on rod (A) and front rod (N), making sure to hold rod ends when pushing universal joint
(M) on rods (A and N).
14. Line up hole in universal joint (M) with hole in rod (A).
15. Using pliers, start new pin (P) in hole in universal joint (M) and hole in rod (A).
16. Using hammer, drive new pin (P) all the way in hole.
17. Using steel rod, line up hole in universal joint (M) with hole in front rod (N).
18. Using pliers, start new pin (Q) in hole in universal joint (M) and hole in front rod (N).
19. Place wood block under rod (P) as shown, and using hammer, drive new pin (Q) all the way in hole. Remove
wood block.
Go on to Sheet 8
TA130816
11-20