TM 9-2350-222-34-1
REAR DRAIN VALVE INTERCONNECTING (INTERMEDIATE) CONTROL ROD AND UNIVERSAL JOINTS
REPLACEMENT (Sheet 6 of 9)
INSTALLATION:
1. With rod (A) in vise, push universal joint (B) on
either end of rod (A).
2. Using steel rod, line up hole in universal joint (B)
with hole in rod (A).
3. Using pliers, start new pin (C) in hole in universal
joint (B).
4. Using hammer, drive new pin (C) in hole of
universal joint (B).
5. Push rod (A) through hole in block (D).
6. Pull rod (A) toward front of vehicle.
7. Push rear intermediate control rod (E) in
universal joint (B).
8. Using steel rod, line up hole in universal joint (B)
with hole in rear intermediate control rod (E).
Go on to Sheet 7
TA130815
11-18