TM 9-2350-222-34-1
ROADWHEEL ARM REPAIR (NUMBER 1 LEFT AND RIGHT) (Sheet 4.1 of 7)
ASSEMBLY:
1.
Position shock absorber bearing (A) on arm (B).
Install replacer over bearing (A) and arm (B).
Turn replacer nut until bearing (A) is centered in
arm (B). Remove replacer.
2.
Stake bearing (A) to arm (B) at three equally
spaced locations on each side of bearing (A).
NOTE
If replacing bearing for mechanical
track adjusting link, perform steps 2.1
and 2.2.
If replacing bearing for
grease actuated track adjusting link,
perform steps 2.3 and 2.4.
2.1.
Position bearing (C) on arm (B). Install bearing
driver over bearing (C). Turn nut of bearing
driver until bearing (C) is centered in arm (B).
Remove bearing driver.
2.2.
Stake bearing (C) to arm (B) at three equally
spaced locations on each side of bearing (C).
Go to step 3.
2.3.
Position bearing (D) on arm (B). Secure bearing
tool assembly to bearing (D) with screw and nut.
Install puller to bearing tool assembly and drive
bearing (D) in arm until centered. Remove
bearing tool assembly and puller.
2.4.
Stake bearing (D) to arm (B) at three equally
spaced locations on each side of bearing (D).
Go on to step 3.
Go on to Sheet 5
Change 3 9-5