TM 9-2350-222-34--1
ROADWHEEL ARM REPAIR (NUMBER 1 LEFT AND RIGHT) (Sheet 4 of 7)
8.
Using hammer and chisel cut off stakes on three
places each side of shock absorber bearing (G)
and track adjusting link bearing (H).
NOTE
if your vehicle is equipped with mechanical track adjusting link perform steps 9 and 10; if
equipped with grease actuated track adjusting ink perform steps 9 and 11.
9.
Install replacer on bearing (G). Turn replacer nut
until bearing (G) is removed. Throw bearing (G)
away.
10.
Install bearing driver on bearing (H). Turn nut of
bearing driver until bearing (H) is removed.
Throw bearing (H) away.
11.
Secure bearing tool assembly to bearing (H) with
screw and nut. Install puller to bearing tool
assembly and remove bearing (H).
Throw
bearing (H) away.
Change 3 9-4.1/(9-4.2 blank)