TM 9-2350-222-34-1
BRAKE SLAVE CYLINDER REPAIR (Sheet 2 of 6)
CAUTION
Hold tube (D) in position while removing screws (C) as spring is compressed in cylinder.
2. Using 1/2 inch wrench, remove two screws (C)
holding tube (D) in slave cylinder (A).
3.
Remove tube (D), retainer (E), spring (F), and
tube (G) from slave cylinder (A). Throw tube (G)
and spring (F) away.
4.
Using 3/8 inch wrench, remove bleeder valve (H)
from slave cylinder (A).
5.
Using 1 inch wrench, remove plug (J) and
preformed packing (K). Throw away packing
(K).
6.
Move slave cylinder in vise to expose pin (L).
7.
Using drift punch and hammer, remove pin (L)
and remove slave nut (M) from slave cylinder
(A).
Go on to Sheet 3
8-16
