TM 9-2350-222-34-1
ENGINE REPLACEMENT (2D ENGINE) (Sheet 17 of 18)
32. Using 15/8 inch wrench, install two washers (AX)
and adapters (AY) to oil cooler (AZ) on right side of
engine.
33. Position inner oil cooler tubes (BA) to inner
adapters (AY) and (BB).
34. Using 1-1/2 inch wrench, tighten nut (BC) to adapter
(AY).
35. Using 1-1/2 inch wrench, tighten nut (BD) to adapter
(BB).
36. Position outer oil cooler tube (BA) to adapter (BB).
37. Using 1-1/2 inch wrench, tighten nut (BC) to adapter
(AY).
38. Using 1-1/2 inch wrench, tighten nut (BD) to adapter
(BB).
39. Using procedures described in steps 32 thru 38,
install the two tubes, adapters, and washers to left
oil cooler.
40. Install engine mounts (TM 9-2350-222-20-1).
40.1 Install left and right exhaust ejector tube (TM 9-
2350-222-20-1-3) if replacing a 2DA engine.
41. Install engine shroud and supports (TM 92350-222-
20-1).
Go on to Sheet 18
TA248761
Change 2 3-34
