TM 9-2350-222-34-1
ENGINE REPLACEMENT (2D ENGINE) (Sheet 12 of 18)
8. Push transmission input shaft (L) into
transmission.
9. Using pinion turning wrench, turn transmission
until splines aline and shaft (L) will slide in and
seat properly.
10. Remove pinion turning wrench.
11. Using retaining ring pliers, install retaining ring
(M) on input shaft.
12. Position gasket (N) onto plug (P), and using 1-
1/8 inch socket and torque wrench, tighten plug
(P) to 50-60 lb-ft (68-81 Nm).
Go on to Sheet 13
Change 3 3-29