TM 9-2350-222-20-2-3-2
36-27. SAFETY SWITCH AND GUARD REMOVAL PROCEDURE (CONT)
Procedure
Using pencil and masking tape, mark top of switch (1) so that switch is put in proper
1.
position during installation.
Using screwdriver, remove two screws (2) and two lockwashers (3).
2.
Remove safety switch (1) and guard (4) from switch bracket (5).
3.
Disconnect trigger switch lead connector (6) from safety switch (1) (JPG).
4.
Disconnect circuit 111 power lead connector (7) from safety switch (1) (JPG).
5.
END OF TASK
Para 36-27 Cont
36-63
