TM 9-2350-222-20-1-5
TACHOMETER REAR FLEXIBLE SHAFT REPLACEMENT (EARLY MODEL) (Sheet 5 of 7)
Using steel rule, measure back approximately 10 inches from tachometer adapter end (B).
From 10-inch mark, wrap shaft (G) with tape (Item 58, Appendix D) 5 inches to rear until shaft (G) is
approximately 5/8-inch in diameter.
Place heat shrinkable plastic tubing (H) over tape.
8.
CAUTION
Avoid overheating in one spot as plastic tubing melts easily.
9.
Using heat gun, shrink tubing by moving hot air back and forth over entire length of tubing.
1.
Person in powerplant compartment attach
wire (Item 59, Appendix D) to end of shaft (A).
2.
Person in turret pull on wire to thread
shaft (A) back into position.
Go on to Sheet 6
TA253878
