TM 9-2350-222-20-1-5
PERSONNEL HEATER REPAIR (Sheet 6 of 8)
Heater Flame Detector Switch Replacement (Sheet 2 of 2)
INSTALLATION:
1.
Mount flame detector switch (A) to personnel
heater.
2.
Using screwdriver, install two screws (B),
lockwashers (C), and nuts (D).
3.
Connect four leads to four terminals (E), two
to N.O. (normally open), two to N.C.
(normally closed) switch terminals (E) with
four screws (F) and lockwashers (G).
4.
Make sure all labels (H) are to proper
terminals.
5.
Using screwdriver, tighten four screws (F).
6.
Install heater cover (page 19-26, steps 7 and 8).
7.
Connect electrical connector (page 19-26, steps 9
and 10).
8.
Connect fuel inlet line to quick-disconnect (page
Perform operational check (TM 9-2350-222-10).
9.
End of Task
TA141254
19-29
