TM 9-2350-222-20-1-5
REAR DRAIN VALVE REAR ROD, COUPLING, AND CLEVIS REPLACEMENT
(Sheet 5 of 6)
4.
Put end of rod (C) through hole in bracket (D).
5.
Install coupling (E) and coupling jamnut (F) on
end of rod (C).
Adjust coupling (E) and coupling jamnut (F)
6.
until original length of threads can be
measured on rod (C) with coupling jamnut (F)
finger tightened against coupling (E) (page
Using wrench, tighten coupling jamnut (F)
7.
against coupling (E) while holding coupling (E)
with another wrench.
Line up coupling (E) with rear intermediate
8.
control rod (G).
Go on to Sheet 6
16-154
