TM 9-2350-222-20-1-5
DRIVER'S HATCH NIGHT VIEWER LATCH REPAIR (Sheet 5 of 10)
CLEANING AND INSPECTION:
1.
Using dry cleaning solvent (Item 54, Appendix D) and rags, remove debris and dirt from all parts.
2.
Inspect all parts for damage or wear. Replace defective parts.
ASSEMBLY:
1. Secure support (A) in vise.
2. Using fingers, place new teflon washer (B) on
shaft (C).
NOTE
Using knife, remove sharp edge (chamfer) of teflon washer (B)
at hole. If it does not fit flush against shoulder of shaft (C),
remove washer, reverse it, and reinstall.
3.
Place spring (D) on sleeve (E) with loop of
spring over hole in sleeve.
Position assembled spring (D) and sleeve
4.
(E) between mounting arms of support (A),
with loop end of spring nearest end mount-
ing arm.
Go on to Sheet 6
