TM 9-2350-222-20-1-5
DRIVER'S HATCH HANDLE AND SEAL (PASSIVE NIGHT VISION) REPAIR (Sheet 2 of 2)
ASSEMBLY:
1.
Using putty knife, apply thin layer of
groove of cover (A).
NOTE
Use care to keep adhesive in
groove only. Wait until adhe-
sive is tacky before installing
new packing (see instructions
on container).
2.
Lay new packing (B) into groove carefully
without stretching or compressing it.
Remove any excess adhesive on or around
3.
packing with dry cleaning solvent (Item
Slip spring (C) loop end first over end of
4.
handle (D).
5.
Wind spring about 1/4 turn and insert end
of handle (D) in retainer on cover with
tang of spring (C) over retainer.
6.
Holding handle in place, position strap (E)
and using cross-tip screwdriver, install two
screws (F) and washers (G).
End of Task
TA253614