TM 9-2350-222-20-1-4
TRACK SUPPORT ROLLER WHEEL AND HUB REPAIR (Sheet 2 of 5)
NOTE
If special tools do not fit into hub,
stop work and order a complete
new support roller assembly, then
install support roller on tank (page
Position remover-replacer (Item 15, Chapter 3,
2.
Section I) to inside of inner wheel hub cup (B).
Screw handle (Item 10, Chapter 3, Section I)
3.
into remover-replacer from other side of hub
(c).
Using hammer, tap handle to drive inner bearing cup (B) out of hub. Remove cup.
4.
Position other remover-replacer (Item 17,
5.
Chapter 3, Section I) to inner edge of outer
bearing cup (D).
6.
Screw handle into remover-replacer from
other side of hub (C).
7.
Using hammer, tap handle to drive outer
bearing cup (D) from hub (C). Remove cup.
TA141328
Go on to Sheet 3
14-46 Change 1
