TRACK SUPPORT ROLLER REPLACEMENT (Sheet 11 of 11)
Place static ground spring (W) into access cover
plate (X) so tang is in hole inside cover plate.
Twist spring (W) into place.
Position new gasket (Y) and cover (X) to hub
flat washers (AA), and screw (AB).
Using 9/16 inch socket, tighten screws
Using grease gun to lube fitting on cover plate,
lube roadwheel (LO 9-2350-222-12).
If jack was used, lower it. Remove jack and planks (or plates).
Have second person start engine and move tank so two centerguides can be installed (TM
Install centerguides (TM 9-2350-222-10).
Test drive tank a short way (TM 9-2350-222-10).
Adjust track tension (TM 9-2350-222-10).
End of Task
14-44 Change 1