TM 9-2350-222-20-1-4
SERVOBANDS ADJUSTMENT (Sheet 2 of 3)
2.
Using 1-1/16 inch wrench to hold adjusting
screw (D) and socket wrench socket on locknut
(E), loosen locknut (E) enough to allow
adjustment of adjusting screw (D) without
locknut
(E)
coming
in
contact
with
transmission case (F).
Using torque wrench and 1-1/16 inch socket on adjusting
3.
ft (34-41 N.m).
4.
Back off adjusting screw (D) approximately one full turn to the nearest flat that will aline with lock plate
(C) when lock plate (C) is installed.
Scribe mark on adjusting screw (D) and transmission case (F) to record alined position.
5.
I
Go on to Sheet 3
11-64
Change 5
