TM 9-2350-222-20-1-4
SHIFTING CONTROL AND RELATED PARTS REPAIR AND REPLACEMENT
(Sheet 10 of 15)
Using vise, press new bearing (G) in link (H)
4.
until flush with outer surfaces of link.
NOTE
Adjust rod (J) to measure same length as original rod (see
5.
Position rod (J) into intermediate link (K).
6.
Install bolt (L) through intermediate link (K)
and rod (J).
7.
Install link (K) in vise.
8.
Using 9/16 inch socket and torque wrench,
tighten bolt (L) to 15-20 lb-ft (20-27 N-m).
9.
Remove intermediate link (K) from vise.
10.
Position intermediate link (K) in place on
shaft (M) with holes alined.
11.
Using hammer, install pin (N).
Go on to Sheet 11
TA253381
11-34 Change 1