TM 9-2350-222.20-14
ENGINE STARTER WIRING HARNESS REPLACEMENT
(2D ENGINE) (Sheet 4 of 6)
2.
Feed female connector cables between exhaust
manifold (D) and engine.
3.
U s i n g 3/4 inch wrench, secure female
connector cables (E) and (F), light cable (G),
and ground cables (H) to starter (J) with nut
and new lockwasher (K).
NOTE
Note position. Single male prong
goes on top.
4.
Using screwdriver and 3/8 inch wrench, secure
male connector (L) to bracket (B) with four
screws, new lockwashers, and nuts (M).
Go on to Sheet 5
TA139926
10-375
