TM 9-2350-222-20-1-4
ENGINE WIRING HARNESS REPLACEMENT (2D ENGINE) (Sheet 12 of 12)
47. Place wiring harness (A) alongside of engine
and place electrical connector (BK) in position
in engine disconnect bracket (BL).
48. Place four clamps (BM) over wiring harness (A).
49. Using 7/8 inch wrench, install eight screws
50. Make sure wiring harness (A) and electrical
connector (BK) are in position in engine
disconnect mounting bracket (BL).
51. Using screwdriver and 3/8 inch wrench,
install four screws, new lockwashers, and
nuts (BQ.).
52. Install powerplant (page 5-37).
End of Task
TA139901
10-350
