TM 9-2350-222-20-1-4
RIGHT TAILLIGHT - STOPLIGHT ASSEMBLY REPAIR (Sheet 3 of 3)
ASSEMBLY:
1.
Insert two leads (A) through body assembly (B).
2.
Install socket and wiring assembly (C) by pressing in grommet (D).
3.
Using cross-tip screwdriver, install three screws (E) through plate (F) and grommet (D).
4.
Using cross-tip screwdriver, install two screws (G) and two new lockwashers (H).
5. Install two lamps (J).
6.
Coat new preformed packing gasket (K) with
silicone compound (Item 32, Appendix D) before
installation.
7.
Place new preformed packing (K) in door
assembly (L).
NOTE
Wires are located at bottom of body assembly (B) for
positioning of door assembly (L) as shown.
8.
Using flat-tip screwdriver, install six screws (M)
door assembly (L), and six retaining rings (N).
Install lamp assembly (page 10-225).
9.
10. Perform test on taillight assembly (TM 9-2350-222-10).
End of Task
TA139783
10-228
