TM 9-2350-222-20-1-4
MASTER CONTROL PANEL REPAIR (Sheet 47 of 65)
Personnel Heater Wiring Harness Replacement (Sheet 4 of 5)
INSTALLATION:
1.
Apply silicone compound (Item 32, Appendix D) to male connector (A).
2.
Connect connector (A) to join circuit 400.
3.
Using flat-tip screwdriver, secure electrical leads (circuits 400/405, 405, 401, 402, and two 407)
with screws and washers to their respective terminals of switch, as shown.
4.
Place switch (B) in position on panel.
5.
Place guard (C) and new lockwasher (D) over switch (B).
6.
Using pliers, install nut (E) securing switch (B), guard (C), and new lockwasher (D) to panel.
TA139657
10-101
