TM 9-2350-222-20-1-4
STARTER REPLACEMENT (Sheet 4 of 7)
NOTE
The top and front fasteners have
bolts (Y) which pass through the
engine hull housing (AA) and must
be held in place when removing
The
t h e self-locking nuts [Z).
inboard fastener has a stud and
will not require a wrench to hold it
in place.
10.
Using 15/16 inch wrench on bolts (Y) and
special wrench (Item 3, Chapter 3, Section I) on
seif-locking nuts (Z), loosen and remove three
self-locking nuts (Z) securing starter (F) to
starter drive adapter (AB). Throw nuts away.
11.
Using two persons, ease starter out of starter drive adapter (AB). Remove starter from engine.
12. Remove gasket (AC) from starter drive adapter (AB). Throw gasket away.
Go on to Sheet 5
TA 139584
10-29