TM 9-2350-222-20-1-4
NOTE
T h e r e is a positive (+) and
negative (-) shown on slave
receptacle.
5.
With one person in driver's compartment with
6.
(+) (H) side and black test lead (E) in negative
(-) side of slave receptacle (F)
Person in drive's compartment, start engine
7.
(TM 9-2350-222-10) and run for one half hour at
1000 RPM.
Turn on service headlights (TM 9-2350-222-10).
8.
NOTE
Make sure person in turret has full
view of multimeter.
Person in turret, using screwdriver, adjust
9.
voltage control box (B) until multimeter
indicates 26-30 VDC.
10.
If voltage cannot be obtained, refer to
troubleshooting (page 4-5261).
11.
Shut down engine and turn off service
headlights (TM 9-2350-222-10).
12.
Install access plug (C) in voltage control box (B).
13.
Remove test leads (D) and (E) from slave
receptacle (F).
End of Task
TA139578
10-23