TM 9-2350-222-20-1-3
MANIFOLD HEATER (LEFT AND RIGHT BANK) FUEL RETURN TUBE ASSEMBLY
REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Cleaning and Inspection
Installation
TOOLS: 5/16 in. combination box and open end wrench
8 in. adjustable wrench
Flat-tip screwdriver
Hammer
9/16 in. combination box and open end wrench (2 required)
1/2 in. socket with 1/2 in. drive
1/2 in. combination box and open end wrench
SUPPLIES: Rags (Item 65, Appendix D)
Sealing compound (Item 27, Appendix D)
Dry cleaning solvent (Item 54, Appendix D)
Container -
PERSONNEL: TWO
PRELIMINARY PROCEDURES: Remove powerplant (page 5-1)
CAUTION
When removing or installing fuel lines, care must be taken not
to damage fittings and threads or twist or distort fuel lines or
hoses.
NOTE
There are two manifold heater fuel return tube assemblies,
one for left bank and one for right bank.
Removal and
installation procedures for both tube assemblies are similar.
This procedure covers right bank tube assembly.
Go on to Sheet 2
TA141561
7-381