TM 9-2360-222-20-1-3
FUEL TANK PLUG AND BRACKET REPLACEMENT (Sheet 1 of 3)
1/2in. socket with 1/2in. drive
1/2 in. combination box and open end wrench
3/4in. socket with 1/2in. drive
9/16 in. combination box and open end wrench
Stud remover
SUPPLIES:
Lockwasher (MS35338-45) (2 required)
Grease (Item 36, Appendix D)
REMOVAL:
1.
Using 3/4 inch socket, loosen bolt (A) holding
doors (B). Open three doors (B) to gain access
to left fuel tank.
2.
Using 1/2 inch socket, remove two screws (C),
washers (D), and lockwashers (E) holding
bracket (F) to fuel tank (G). Throw lockwashers
away.
NOTE
If flats of plug (H) are badly
rounded or deformed, throw plug
away.
3.
Using 9/16 inch wrench or stud remover,
remove plug (H) from fuel tank (G).
TA253267
Go on to Sheet 2
Change 1 7-175
