TM 9-2350-222-20-1-3
REPLACEMENT (2D ENGINE) (Sheet 20 of 23)
45.
On early model, reach through engine
access cover opening and use 7/16 inch
wrench to install accelerator bolt (AC) to
hold accelerator linkage clevis (AD) to rod
end (AE).
45.1. On late model, reach through engine
access cover opening and mount rod ends
(AE.1) to accelerator linkage lever (AD.1)
and fuel shutoff clevis (AD.2).
45.2. On late model, install two self-locking bolts
(AE.3). Using 7/16 inch wrench, tighten
both bolts (AE.3).
EARLY MODEL
46.
On early model, reach through engine access
cover opening and remove protective
coverings from two primary fuel lines (AF)
and quick-disconnect fittings (AG).
46.1 On late model, reach through engine access
cover opening and remove protective
coverings from primary fuel line (AF.1)
and quick-disconnect fitting (AG.1).
LATE MODEL
47.
On early model, reach through lower engine
access cover opening and manually connect
two priming fuel lines (AF) to quick-discon-
nect fittings (AG).
47.1 On late model, reach through lower engine
access cover opening and manually connect
priming fuel line (AF. 1) to quick-disconnect
fitting (AG.1),
Go on to Sheet 21
TA249056
5-44.1/(5-44.2 blank)
Change 2
