TM 5-5420-226-20-1 Symptom-73 DETAILED TROUBLESHOOTING PROCEDURE T SUPPORT SYSTEM -   PERSONNEL HEATER (Continued) Does    meter indicate 18  to   30   volts    dc? I n ! Check for electrical power at heater to basket disconnect harness connector, contact C  (CKT   402). Second Technician (Operator’s Station) l   Set    PERSONNEL HEATER HI/LO switch OFF. First TechnicIan (Commander’s Station) l   Install    basket-control panel heater harness at   basket disconnect. l   Disconnect heater to basket disconnect harness at personnel heater. l   Connect red probe of meter to harness connector contact C   (CKT 402)    and    black probe to   ground. l   Set   PERSONNEL HEATER HI/LO switch ON-LO. l   Check   if  meter    indicates 18  to   30   volts    dc. ~ I AOi w \ ( *IEI=+EEJ , CONTACT PERSONNEL HEATER 1 l   Set   PERSONNEL HEATER H1/ LO   switch OFF. l   Inspect heater to basket disconnect harness for    bent/ broken connector contacts or loose    CKT   402    wire    at   rear   of connectors. l   Repair    connectors if  defective (page 10-298). l   If connectors are not defective, notify support maintenance of   bad   heater to basket disconnect harness. l   Connect heater to basket disconnect harness    connector to   personnel heater. TA1O 87 4-698