TM   5-5420-226-20-1 DETAILED TROUBLESHOOTING PROCEDURE Symptom-17 VEHICLE O~ERATION -  POWERPLANT, STOPPING -Y (Continued) Check    fuel   shut   off   solenoid lead   (CKT   54A)   at   fuel shut   off   solenoid for   electrical power. Second Technician (Operator’s Station) l   Set   MASTER BATTERY switch OFF. First Technician (Rear of   Crew Compartment) l   Reconnect engine    electrical harness (CKT    54A)  to   fuel shut off solenoid lead   connector. First Technician (Top Deck) l   Have   top   deck   removed (Page 16-21). l   Remove    front   engine   cooling    fan   (page   9-55). First Technician (Engine) l   Disconnect fuel   shutoff solenoid electrical lead    (CKT 5’4A)  from fuel   shut off   solenold. l   Connect   red  probe   of  meter   to  center    contact   of  solenoid electrical lead   connector and    black probe to   ground. Second Technician (Operator’s Station) l   Set   MASTER BATTERY switch ON. l   Momentarily set   ENGINE FUEL SHUT OFF switch in   up   position, then release it. First Technician (Top Deck) l   Check   if  meter    indicates    18 to  30 volts   dc  while   switch    is in   up   position. Does   meter    indicate 18  to   30  volts   dc? \ m II TO   VEHICLE GROUND .  . ^. .,..  . )   , ,{( > ,>. . !, LJ A .\ “, 11 _J I    \ L-—i.. .,– -== — FUEL    SHUT A OFF    SOLENOID FOR   CLARITY QUADRANT ASSEMBLIES NOT   SHOWN Replace fuel   shut   off   solenoid Notify    support maintenance of lead   (page    20-28). defective fuei   shut   off   soienoid/ fuei   injection pump. \ \ TA107000 4-311