TM 5-5420-226-20-1
Item
No.
32
P r e v e n t i ve
Interval
Semiannual
M a i n t e n a n ce
C h e c k s a n d S e r v i c e s f o r M 4 8 A 5 A V L B H u l l -
Location
Item to
Check/Service
Dust Detector
Filter Strip (Left
and Right Sides)
(If Equipped)
- Continued
C o n t i n u ed
Procedure
Service dust detector filter strip.
Cut off approximately 2-inches from
end of filter strip.
Pull filter strip so that approximate-
ly 1/2-inch will extend past edge of
cover when filter strip is installed.
Install filter strip and retainer in
cover. Filter strip must be approxi-
mately 1/2-inch past edge of cover.
Ensure all orifices are clean.
Install cover. Tighten three screws.
Perform dust detector operational
test (page 10-298.16).
Not Fully Mission
Capable if:
3-42
Change 6