Switches
Engine Start Switch
Remove locking pin (1) and lift switch cover (2) to
access the switch. Store the locking pin as shown.
OFF (5)—Move switch cover (2) all the way
down to turn off electrical power to the
machine and to shut off the engine.
When the switch is in the OFF position, power is
blocked to all electrical components except for the
engine heater, NATO slave receptacle, SINCGARS,
and PLGR.
ON (4)—Move the switch into the center
position to turn on the electrical power to the
machine.
START/INDICATOR CHECK (3)—Move and
hold the switch all the way up to engage the
starter and crank the engine. If the engine is
already running, move the switch into the START
position to turn on the indicator lights and check
indicator operation.
NOTE: The starter will not engage if the transmission
control lever is not in NEUTRAL, or the engine is
already running.
NOTE: Refer to “Indicator Check Function,” in this
section, for a description of the lamp check system.
NOTICE
Do not crank the engine for more than 30 seconds.
Allow the starter to cool for two minutes before
cranking again.
Turbocharger damage can result if the engine rpm is
not kept low until the engine oil gauge verifies that the
engine oil pressure is sufficient.
1
2
3
4
5
2
1
Monitoring Systems and Cab Features
17
Operation Section
Monitoring Systems and Cab Features
TM5-2430-200-10
