Quarterly (3) Check cable for fraying, kinking, and
signs of damage or rusting.
• The equipment is not
ready/available if the cable is
kinked or frayed. For additional
information about checking
cables, refer to “FM-5-125,
Rigging, Techniques,
Procedures, and Applications.”
Quarterly (4) Check the doubling block hook for
wear and damage.
• The equipment is not
ready/available if the hook is
worn, cracked, or bent beyond
10 degrees.
21
CAB
NOTE: For illustrations of the lubrication
points, refer to “Maintenance Section,
Lubrication Chart” and “Every 250 Service
Hours or 3 Months” in this manual.
Quarterly (1) Lubricate the cab pin grease fittings.
There are a total of two fittings.
Quarterly (2) Operate the engine coolant heater if it
is installed on the machine.
• The equipment is not
ready/available if the engine
coolant heater does not
operate correctly, and
temperatures below –32°C
(–25°F) are expected.
PREVENTIVE MAINTENANCE CHECKS AND SERVICES – DEUCE
Item
No.
Interval
Item To Be Inspected
Equipment Status
A–23 (A-24 Blank)
TM5-2430-200-10
