TM 5-2350-262-20-2
AG Coat threads of track pin (4) and face (washer
side) of two locknuts (5) with grease.
AH Install washer (6) and locknut (5) on track pin
(4). Tighten locknut (5) to end of threads.
AI
Install locknut (7), retained from removal, on
track pin (4).
Note
Track pin may have to be turned slightly
with 15-inch adjustable wrench during
installation to align pin with track shoe
bushings.
AJ Using hammer and 15-inch adjustable wrench,
install track pin (4) on track (1) by driving out
driftpin with track pin (4).
AK Remove and discard locknut (7), retained
from removal.
Change 3 4-863
WARNING
When using hammer with driftpin or
track pin, wear safety goggles. Failure
to comply may result in injury to
personnel.
CAUTION
If pin binds, bushings are not properly
aligned. Remove pin and tighten or
loosen track connecting fixtures as
necessary until bushings are aligned.
Failure to comply may result in damage
to track shoe bushings.
1
