TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (ENGINE COMPARTMENT)
(Sheet 14 of 15)
36.1 Position control assembly (AH.1) to bellcrank
(Z) and install pin (AH.2),
36.2 Using pliers, install cotter pin (AH.3) on pin
(AH.2).
36.3 Using 9/16 inch socket, install two screws
(AH.4) securing control assembly bracket
(AH.5).
37.
Using 3/4 inch socket, install nuts (AJ) and (AK). Using 3/4 inch socket and torque wrench,
tighten nuts to 55-60 Ib-ft (74-81 N.m).
38.
Position clamps (AL) and (AM) on control assembly.
39.
Install screws (AN) and new lockwashers (AP) to secure clamps (AL) and (AM). Using 3/4 inch
socket, tighten screws.
40.
Adjust clamp (AM) to maintain minimum 3/4 inch clearance between control assembly and
turbocharger.
Go on to Sheet 15
TA253449
Change 1
13-97