HYDRAULIC RESERVOIR REPLACEMENT (Sheet 5 of 15)
Move reservoir (AN) to turret opening in hull and
Using lifting device, remove reservoir (AN) from
vehicle and place in suitable work area using
care not to damage any components.
Remove rope sling.
Using 1-1/4 inch wrench on tube assembly nut
(AP) and 1-3/8 inch wrench on union (AQ),
disconnect nut and remove union and packing
(under union). Throw packing away.
Using 1-1/2 inch wrench, disconnect nut (AR)
Using 1-1/2 inch wrench, disconnect two tube
and remove assembled parts (AS).
assembly nuts (AT).
Using 3/4 inch socket, remove four screws and
Lift off control valve (S) with its attached parts.
Remove packing from reservoir and throw away.
Go on to Sheet 6