TM 9-2350-222-34-1
REAR DRAIN VALVE CONTROL ROD BUSHING AND SEALS REPLACEMENT (Sheet 3 of 3)
2.
Using hammer and rod, drive second seal (A) in block (C) until lip of second seal (A) is flush with block (C).
3.
Remove rod from vehicle.
4.
5.
Install front intermediate rod (page 11-18, steps 1 thru 19).
6.
Using grease gun, lubricate bushing through grease fitting (D).
7.
Make sure rear drain valve opens and closes smoothly.
8.
Install batteries (TM 9-2350-222-20-1).
End of Task
TA130821
11-24