TM 9-2350-222-34-1
FINAL DRIVE REPAIR (Sheet 22 of 30)
NOTE
Tag both parts of each bearing so
that same parts can be paired up
later. Keep both parts of a bearing
cooling.
33.
Place two bearings (S) (outer races with rollers)
on dry ice or in refrigerator freezer for 30 to 45
minutes.
34.
Ensure bearing bore (T) of case (U) and bearing
pocket (V) of carrier (N) are clean, dry, and free
of foreign material.
35.
Position cap (W) in arbor press. Position seal
(X) on cap (W) with rubber seal facing down.
Using wood block and arbor press, press seal
(X) into cap (W) until seal (X) is flush with cap
(W).
Go on to Sheet 23
Change 3 7-22