BODY, ELBOWS, DELAY BOTTLE, AND RELATED TUBES REPLACEMENT (EARLY MODEL)
(Sheet 7 of 7)
Insert body (L) into vise.
Using adjustable wrench, install three bush-
ings (M) in body (L).
Using pipe wrench, install and position as
shown, three elbows (N) and (P), to bush-
Remove body from vise.
Position assembled body and elbows (Q) to
hull floor just rearward of cylinder mount-
Using 7/16 inch socket, install two screws
and washers (R) to secure body (Q) to hull.
Connect tube assembly (C) to elbow (N).
Using torque wrench and 1-1/4 inch crow-
foot, tighten tube assembly (C) nuts at
each end 40-55 lb-ft (54-75
End of Task