STEERING LEVER ASSEMBLY REPAIR (Sheet 2 of 5)
Using 9/16 inch wrench, remove
bolts (A) securing control rod (B)
and connecting rod (C) to lever
Remove and position aside control
rod (13) and connecting rod (C).
Remove flaremable materials, such as spilled fuel or oil,
from hull. Place wet rags or nonflammable cloth under
relay lever assembly. Follow safety procedures as listed
in TM 9-237 "Operator's Manual for Welding Theory and
Application." Station someone with a fire extinguisher
in the immediate area.
Use effective chip guarding and personnel protective
equipment (goggles/shield, gloves etc.) during cutting
and welding operations. Failure to do so could result in
Using cutting torch, cut lower link (E) off
pin (F). Discard lower link (E) and washer
Using file or grinder, remove any burrs from
end of pin (F).
Go on to Sheet 3
15-24.2 Change 5