SHIFT LINKAGE ADJUSTMENT (Sheet 11 of 20)
Using 9/16 inch wrench, adjust shifting rod
bearing end (AG) by turning clockwise or
counterclockwise until screw (AF) drops freely
through clevis (AH) and shifting rod bearing
Using 9/16 inch wrench, install screw (AF).
Using crowfoot and torque wrenches, tighten
jamnut (AD) to 15-20 lb-ft (20-27 N.m).
Remove locating pin from alinement hole (AC).
Using 9/16 inch socket and torque wrench,
tighten screw (AF) to 15-20 lb-ft (20-27 N.m).
Go to right rear of vehicle and try to insert locating pin into alinement hole (C and through Clevis
(AB). If locating pin can be inserted, shift linkage is in adjustment. Remove locating pin and go
to step 129. If locating pin cannot be inserted, go on to step 74.
Go on to Sheet 12
11-12 Change 1