TM 9-2350-222-20-14
SHIFT LINKAGE ADJUSTMENT (Sheet 7 of 20)
33. Using 9/16 inch wrench, remove screw (Y)
and shifting rod bearing end (Z) from clevis
(AA).
34. Using 9/16 inch wrench, adjust shifting rod
bearing end (Z) clockwise until shifting rod (T)
is past hole (X).
35. Using 9/16 inch wrench, install screw (Y) through clevis (AA) and shifting rod bearing end (Z).
36. Using crowfoot and torque wrenches, tighten jamnut (R) to 15-20 Ib-ft (20-27 N.m).
Using 9/16 inch socket and torque wrench, tighten screw (Y) to 15-20 Ib-ft (20-27 N.m).
37.
38. Using 9/16 inch wrench, adjust shifting rod
bearing end (U) by turning clockwise or
counterclockwise until screw (S) slides freely
through clevis (V) and shifting rod bearing
end (U).
39. Using 9/16 inch wrench, install screw (S) through clevis (V) and shifting rod bearing end (U).
40. Using crowfoot and torque wrenches, tighten jamnut (Q) to 15-20 Ib-ft (20-27 N.m).
41. Remove locating pin from alinement hole (P).
42. Using 9/16 inch socket and torque wrench, tighten screw (S) to 15-20 Ib-ft (20-27 N.m).
TA25337
Go on to Sheet 8
11-8 Change 1