TM 9-2350-222-20-1-3
TRANSMISSION SHROUDS REPLACEMENT (Sheet 2 of 8)
Right Intermediate Shroud Replacement (Sheet 2 of 5)
REMOVAL:
NOTE
right
When
removing
the
i n t e r m e d i a t e shroud on a 2A
engine r e m o v e engine wiring
harness
page
a c c o r d i n g to
10-327, steps 1 thru 7 and
proceed to step 5 of this
procedure. When removing the
rigid intermediate shroud on a
2D engine, start with step 1 of
this procedure.
1.
Using spanner wrench, disconnect connector (A)
2.
Remove grommet (B) from shroud (C) and cable
assembly (D).
3.
Inspect grommet (B) for defects. If defective,
replace grommet.
4.
Pull cable assembly (D) through shroud (C).
TA1402
Go on to Sheet 3
9-40